Step 4: Starting Cutting Output

WARNING

Never touch the print-head carriage while output is in progress.

The print-head carriage moves at high speed. Coming into contact with the moving carriage may cause injury.

Procedure
  1. Close the front cover.
  2. Check that [SETUP] is lit.
    If [SETUP] is not lit, the setup is not completed. Lower the loading lever, and then press [ENTER].
  3. Check that the screen shown below (the top menu) is displayed.
    If the top menu is not displayed, press [MENU].


  4. Send the output data from the computer.
    For information on how to create the output data, refer to the documentation for the included software RIP.

    IMPORTANT:

    Output Is Not Possible in These Situations

    • The machine does not run when a cover (front, left, right, or ink slot) is open.

    • Data from the computer is not accepted when [SETUP] is dark.

    • Data from the computer is not accepted when you are not at the top menu.

    Points that must be observed

    • Never open a cover (front, left, or right) while output is in progress. Doing so interrupts printing.

    • During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub against the print heads, which may result in a paper jam or damage to the heads.

    • Keep the loading lever raised when the machine is not in use.

    When not using the machine, remove any media and store it in a suitable environment.

    • If the machine is left with the media loaded, the media may be damaged, which may adversely affect printing. When not using the machine, remove any media and store it in a suitable environment.