1. Clean the print head caps.

Procedure
  1. Remove any media.
  2. Press [FUNCTION].
  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [ENTER].
    After "NOW PROCESSING.." is displayed, the screen shown below appears.
    Also, the print head moves to the left end of the platen.


    IMPORTANT:

    Do not press [ENTER] at this stage. Press [ENTER] after cleaning is complete. If you press [ENTER] at this stage, wait for the screen to change as shown in the following figure, and then press [ENTER] again.





  5. Open the right cover.


  6. Touch the location shown in the figure to discharge any static electricity.


  7. Moisten the cleaning stick with the cleaning liquid.
    IMPORTANT: Be sure to use one of the included cleaning sticks.


  8. Clean the locations shown in the following figure.
    Be especially careful to clean away any fibrous dust (lint).
    SG2-640_ManualCleaning_2-1
  9. When you have finished cleaning, close the right cover.