1. Loading the Nozzle Drop-out Test Paper

Perform a nozzle drop-out test using the included nozzle drop-out test paper.

Procedure
  1. Hold the position shown in the figure, rotate it 180 degrees inward, and then open the front cover.
    BD-8_FcoverOpen
  2. Load the included nozzle drop-out test paper.
    Place the nozzle drop-out test paper so that it lines up with the bottom right corner of the white frame, and then fix it in place using tape or some other implement.
    IMPORTANT

    For details on the types of nozzle drop-out test paper used and ways to fix the paper in place, refer to the user's manual.

    SF8 User's Manual > Basic Handling Methods > Basic Information > Introduction > Nozzle Drop-out Test

    TestPrint_Set