Setting the Angle of the Print Surface Manually

Manually set the angle of the print surface on the object. This is suitable when you want to set the distance between the print heads and object to the preferred position. The manual setting takes a little longer than the automatic setting because you need to visually set the height. If the print surface is uneven, there is a limit to the area of unevenness.

Procedure
  1. Load the object.
    Select the media that you want to adjust the table angle for.
  2. Tap Panel_Icon_Menu.
  3. Tap Media Settings - Print Height and Angle Settings.
  4. Change the Rotary Device Angle Adjustment.
    1. Tap Panel_Icon_UpArrow or Panel_Icon_DownArrow on the right side of the screen to adjust the angle gradually while checking it visually.
  5. Tap Save.
  6. Close the front cover.
    MEMO

    Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.

    If you do not open and close the front cover gently, it may break or you may be injured.

  7. Tap Panel_Icon_Back.
    You are returned to the Media Settings screen.