Binder Replenishment

Open the maintenance cover and check the amount of binder.

If there is less than half a tank worth of binder, refill the binder tank.

Procedure
  1. Open the maintenance cover.
  2. Check the amount of liquid in the tank.
    The tank with a tube connected to the filter is the binder tank. The tank with a tube not connected to the filter is the drain tank.

    PB-600_liquid-value_check
  3. If there is not enough binder, replenish it.
    1. Open the cap where no tube is inserted.
      Do not remove the inserted tube. Replenish binder from the opposite opening. Exercise caution to ensure that the tube is not removed during this work.

      PB-600_liquid-value_add_binder
    2. Use a pump (such as those used for transferring oil or kerosene) or a similar tool to fill the tank with binder.
      Exercise caution to avoid overflows caused by putting too much binder into the tank. To prevent the binder and discharged fluid from mixing, use a different pump from that used to transfer discharged fluid to a container.
    3. Tighten the cap on the tank.
  4. Close the maintenance cover.