Fixture Material Replenishment
Be sure to use dedicated fixture material specified by Roland DG Corporation.
When filling this machine with fixture material or replenishing the fixture material, exercise caution to prevent powder from being sprayed into the air.
Procedure
-
Place the inlet of the dust collector close to the supply pool and start collecting dust.
Adjust the position of the inlet so as not to suction the fixture material in the pool.
- Unpack the fixture material and place it on the molding pool.
- Cut off the top part of the fixture material bag with scissors or something similar.
-
Use a pail to ladle out the fixture material from the bag to the supply pool.
Ladle out the fixture material a few times to create a gap at the top of the bag.
- Hold the bag, squeezing its top part shut.
- While squeezing the bag shut, turn it over, placing the top of the bag on the surface of the fixture material in the pool.
- Open the bag by releasing the hand squeezing it shut.
-
Hold the base of the bag and lift it up a little bit at a time.
Pull the bag out slowly.
- Level and flatten the piled fixture material.
- Turn off the dust collector suction.