|
Cover |
For safety, be sure to close the cover before imprinting. Hold the middle area of the cover when opening or closing it. |
|
Head unit |
Moves the head position according to the data sent to the machine. Before imprinting starts, the tip of the head (the marking pin) is aligned to the height of the surface of the material. |
|
Knob |
Determine the head position based on the surface height of the material when performing imprinting without using a head cap. |
|
Head (MPH-90) |
The head is a consumable part. Replace it at the appropriate time. |
|
Marking pin |
Strikes detailed points to imprint text and images on the material. Diamond is attached to the tip of the marking pin. |
|
Power/Movement button |
Pressing this makes the light come on and switches on the power. Pressing it while the unit is on moves the head to the center surface of the table (or the center vise). Pressing it a second time moves the head to the interior left and the table back to the front edge of the unit. To switch off the power, you hold down the button for one second or longer. |
