Starting Cutting Output
Never touch the cutting carriage while output is in progress.
The cutting carriage moves at high speed. Coming into contact with the moving carriage may cause injury.
Do not touch the dancer roller needlessly.
The media take-up unit and feeder may move suddenly, which may result in injury.
- Check that Output possible. is displayed in the status bar on the home screen.
- Send cutting data.Read the crop marks and send the data to cut.IMPORTANT
Output is not possible in these situations
The machine does not run when a cover (front, left, right, or the rear UV shield) is open.
Data from the computer is not accepted when Load media. is displayed.
- On menu screens where Menu operation in progress: Press [Home] to enable output. is displayed, output doesn't start even when data is sent from the computer. When you return to a menu item where output is possible or tap
to return to the home screen, output starts.
Points that must be observed
Do not open a cover (front, left, right, or the rear UV shield) while output is in progress. Doing so interrupts printing.
During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub against the print heads, which may result in a paper jam or damage to the heads.
Keep the loading lever raised when the machine is not in use.
Points that must be observed after output
- When not using the machine, remove any media and store it in a suitable environment.
If the machine is left with the media loaded, the media may be damaged, which may adversely affect printing. When not using the machine, remove any media and store it in a suitable environment.
- Keep the loading lever raised when the machine is not in use.