2. Attach the control box and the left stay.

Procedure
  1. Place the control box (A) on the right stand leg.
    Assemble the motorized media holder (B) by passing it through the rear of the right stand leg. Place the holder outside the printer.
    IMPORTANT The control box (A) and the motorized media holder (B) are connected with a wire. Do not subject this wire to excessive force.

    CtrlBox1

  2. Temporarily tighten the four bolts shown in the figure.
  3. By hand, tighten the temporarily tightened bolts until there is no gap between the left arm and the stand.
    Hold the pieces together so there is no gap between the outside surface of the stand leg and the control box stay when tightening the bolts.
    CtrlBox2

  4. Make sure the protrusion on the stand leg (A) is in the center of the hole on the control box stay (B).
    Move the control box until this protrusion is centered.

    VG3-InstallControlUnitArm_ProtrusioninHole

  5. Fully tighten the bolts in the order of , , .

    VG3-ControlboxTighteningOrder

  6. Place the left stay on the left stand leg in the same manner as the control box.
  7. Temporarily tighten the four bolts on the left stay.
    IMPORTANT After temporarily tightening the bolts, position the stay in the same manner as the control box.
  8. Fully tighten the four bolts in the same order as the control box.