Setting the Suction Function

The flat table suctions the object to be printed on to make it hard to move and easy to load. This function is especially effective when the object to be printed on is thin and light.
Point:

The LEF2-300D spacer table does not have a suction function. When using this spacer table, turn off the suction function.

Procedure
Press [PAUSE/VACUUM].
The suction function turns on (or off).
Point:
The suction function cannot be changed in the following situations.
  • During setup processing
  • When a menu is displayed
  • During printing (including when printing is paused or is being canceled)
  • When an error is displayed
IMPORTANT:

The suction function cannot be used to hold in place curled or thick objects to be printed on. Secure the media in place using a substance such as commercially available adhesive tape affixed directly to the flat table.