Removing the Spacer Table

CAUTION:

Caution: sharp components.

Take care to avoid injuries arising from touching the edges of the spacer table and other such sharp components.

Procedure
  1. Press the sub power button.
  2. Press [SETUP].
    [SETUP] starts to flash.
  3. Press [DOWN] and [▼] to move the flat table to the lowest and frontmost (forward) position.
  4. Remove the screws securing the rear side of the spacer table.

  5. Press [▲] to move the flat table backwards about 100 mm (3.94 in).
  6. Remove the screws securing the front side of the spacer table.
  7. Hold the left and right sides of the spacer table to remove the spacer table.

    : Holding locations



  8. Press and hold [SETUP] to go back.