Jump to main content
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Appendix
Index
Search
Home
Troubleshooting Methods
Machine Problems
The printer unit does not run
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Print Quality Problems
Machine Problems
The Print Heads Do Not Move
The printer unit does not run
Is the power switched on?
Is [SETUP] lit?
Are any covers open?
Is the top menu displayed?
Is [PAUSE] lit?
Has the ink run out?
Is a message displayed on the screen?
Are the cables connected?
Is the status LED for the LAN cable connector lit in green?
Are the LAN settings correct?
Did the software RIP end abnormally?
Is the temperature of the room too low?
The flat table does not move
The Head Gap Sensor Does Not Detect the Object to Be Printed on
It Is Not Possible to Check the Amount of Discharged Fluid in the Drain Bottle
Messages on the Operation Panel
Appendix
The printer unit does not run
Is the power switched on?
Is [SETUP] lit?
Are any covers open?
Is the top menu displayed?
Is [PAUSE] lit?
Has the ink run out?
Is a message displayed on the screen?
Are the cables connected?
Is the status LED for the LAN cable connector lit in green?
Are the LAN settings correct?
Did the software RIP end abnormally?
Is the temperature of the room too low?
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
Troubleshooting Methods
Print Quality Problems
Machine Problems
The Print Heads Do Not Move
The printer unit does not run
Is the power switched on?
Is [SETUP] lit?
Are any covers open?
Is the top menu displayed?
Is [PAUSE] lit?
Has the ink run out?
Is a message displayed on the screen?
Are the cables connected?
Is the status LED for the LAN cable connector lit in green?
Are the LAN settings correct?
Did the software RIP end abnormally?
Is the temperature of the room too low?
The flat table does not move
The Head Gap Sensor Does Not Detect the Object to Be Printed on
It Is Not Possible to Check the Amount of Discharged Fluid in the Drain Bottle
Messages on the Operation Panel
Appendix
