1. Determine the positions of the media (sheet media).

Procedure
  1. Open the front cover.
  2. When the print head height is "LOW" or "HIGH", move the media clamps to the outside of the grit rollers on the left and right edges respectively.


  3. When the print head height is "SpLOW", remove the media clamps.
    The media clamps must be removed to perform setup.
  4. Loosen the retaining screws of the media holders, and then draw them to the left and right ends respectively.


  5. Pass the leading edge of the media between the pinch rollers () and the grit rollers ().


    Point:

    If the media cannot be loaded properly because the media suction is too weak or too strong, press [PAUSE]. Each time you press [PAUSE], the suction force is switched between three levels.

  6. Lower the loading lever (rear).
    The media is held in place.

    At this time, the message "PRESS ENTER KEY TO SET UP" is displayed on the screen, but do not press [ENTER] yet, and proceed to the next step.



  7. (Move to the front of the printer.) Gently hold down the media and raise the loading lever (front).
    The media is released.


  8. Pull out the media over the apron.