Step 1: Removing Media and the Blade Holder

  1. Remove any media.
    If any media has been loaded, remove it.
    If no media is loaded, raise the loading lever.


  2. Remove the media clamps.
  3. Press MENU.
  4. Press ▼ several times to display the screen shown below.


  5. Press ▶ once, and then press ▼ several times to display the screen shown below.


  6. Press ▶ once, and then press ▼ several times to display the screen shown below.


  7. Press ENTER.
    The cutting carriage moves to a position where replacement is possible.
  8. When the following screen is displayed, open the front cover.


    Preparation is complete once the following screen is displayed.


  9. Detach the blade holder.