How to Clean the UV-LED Devices

IMPORTANT:

Important notes on this procedure

  • Before attempting this operation, remove any media.

  • To prevent the print heads from drying out, finish this procedure in 10 minutes or less. A warning beep sounds after 10 minutes.

  • The cloths, alcohol, and similar items used in cleaning are not included with the product.
When a warning beep sounds during cleaning

  • A warning beep sounds 10 minutes after operation starts. Stop work, close all the covers, and then press ENTER to end the manual cleaning mode. After that, restart the procedure from the beginning.

Table 1.
Required items






Anhydrous ethanol or isopropyl alcohol Cloth (that is not fluffy) Rubber gloves
CAUTION:

Do not perform cleaning immediately after printing has finished. (Wait approximately 15 minutes after printing has finished.)

The area around the UV-LED device is hot and may cause burns.

CAUTION:

When using anhydrous ethanol or isopropyl alcohol, be sure to follow the product's usage precautions.

Exercise caution regarding items such as fire, ventilation, and rashes.

CAUTION:

Only use anhydrous ethanol or isopropyl alcohol.

Using chemicals (or similar substances) other than anhydrous ethanol or isopropyl alcohol may lead to UV-LED device damage.

CAUTION:

Use cloth that is not fluffy to wipe off the parts. Do not use a hard material such as metal.

Using cloth that is fluffy or a hard material such as metal may lead to UV-LED device damage.

  1. Remove any media.
  2. Remove the media clamps.
  3. Press FUNCTION.
  4. Press ▶ once, and then press ▼ several times to display the screen shown below.


  5. Press ENTER.
    After "NOW PROCESSING.." is displayed, the screen shown below appears.
    Also, the print head moves to the left end of the platen.


    IMPORTANT:

    Do not press ENTER at this stage. Press ENTER after the work is complete. If you press the ENTER key at this stage, wait for the screen to change as shown in the following figure, and then press the ENTER key again.





  6. Open the front cover.
  7. Open the left covers (top and bottom).


  8. Remove the cut rail.


  9. Touch the location shown in the figure to discharge any static electricity.


  10. Move the print-head carriage to the left end.


    Move the print-head carriage by hand.
    CAUTION:

    When moving the print-head carriage by hand, be sure to hold the specified position.

    Moving it by holding positions other than those specified may deform and damage the cover.



    : Position to hold with your hand

  11. Wet a cloth with anhydrous ethanol or isopropyl alcohol, and then wipe off the base and irradiation unit of each UV lamp with this cloth.
    Wipe the cloth across each UV lamp for approximately 10 round trips until all the dirt is cleared away.


  12. When you have finished cleaning, move the print-head carriage to above the platen.


    Move the print-head carriage by hand.
    CAUTION:

    When moving the print-head carriage by hand, be sure to hold the specified position.

    Moving it by holding positions other than those specified may deform and damage the cover.


    : Position to hold with your hand

  13. Attach the cut rail.


  14. Close the left covers (top and bottom).
  15. Close the front cover.
  16. Press ENTER.
    The screen shown below appears, and then head cleaning starts.


    When the following screen is displayed again, UV-LED device cleaning is finished.