1 Replace the blade.

  1. Remove any media.
  2. Press MENU.
  3. Press ▼ several times to display the screen shown below.


  4. Press ▶ once, and then press ▼ several times to display the screen shown below.


  5. Press ▶ once, and then press ▼ several times to display the screen shown below.


  6. Press ENTER.
    The cutting carriage moves to a position where replacement is possible.
  7. When the following screen is displayed, open the front cover.


    Preparation is complete once the following screen is displayed.


  8. Detach the blade holder.


  9. Replace the blade.
    1. Press the pin (A) to push out the old blade (B).
    2. Insert a new blade (C).
      Orient the tip of the blade (D) correctly.


  10. Install the cutting tool in the cutting carriage.


  11. Tighten the screw.
    Tug the blade holder upward to make sure it does not come loose.


  12. Close the front cover.
  13. Press ENTER.
    When the following screen is displayed again, the blade replacement is finished.


  14. Press MENU to go back to the original screen.