Cutting area

The material's lateral cutting area (direction in which the cutting carriage moves) is determined by the positions of the pinch rollers. The cutting area spans between the two pinch rollers, minus approximately 1 mm (0.04 in.) on each side.


c-area

Pinch roller
Cutting area
Cutting coordinate origin
A Maximum 584 mm (22.99 in.)
B

Type of specified material

  • "ROLL" / "EDGE"
    • Max. 25,000 mm (984.25 in.) *1
  • "PIECE"
    • Max.: Detected length *2
C 10 to 25 mm (0.40 to 0.98 in.)
D Approx. 1 mm (0.04 in.)
E 15 mm
F 50 mm (1.97 in.) or more
*1 The accuracy is guaranteed up to 1,600 mm (62.99 in.).
*2 If the detected length is 1,600 mm (63.00 in.) or longer, the material is determined as "ROLL", and the cutting area length will be set to approximately 25,000 mm (984.25 in.). However, the display does not show the length.