Cutting in the Same Position Repetitively (Overlap)
The Overlap function is used when it is not possible to cut through the material in a single pass, for example, when cutting thick material.
Procedure
Make sure that the material is load to the machine.
-
Press
several times to display the screen shown in the figure.
-
Press
several times to display the screen shown in the figure.
- Press
.
-
Press
several times to display the screen shown in the figure.
- Press
.
-
Press
to set the number of cuts.
Setting Range: 1 to 10
OVERLAP → 2 Normal cut + 2 → 3 cuts are made
-
Press
.
This setting remains enabled until you disable it. If you do not require it, disable it after use.
Press the
key to return to the screen shown in the figure.