This function cuts an extra 1 mm at the start and end of each line. It is effective when you want to produce particularly sharp corners, for example when cutting thicker materials. In most cases the over cut function should be set to "OFF." Set it to ON when you want to ensure that corners are cut cleanly. However, if the over cut function is enabled when cutting small characters or complex shapes, areas of the material that are required may be cut. In such cases it should therefore be set to "OFF."

Procedure

Make sure that the material is load to the machine.
  1. Press several times to display the screen shown in the figure.

     

  2. Press several times to display the screen shown in the figure.

  3. Press .

     

  4. Press several times to display the screen shown in the figure.

  5. Press .

     

  6. Press to select ON.

  7. Press .

    This setting remains enabled until you disable it. If you do not require it, disable it after use.

    Press the key to return to the screen shown in the figure.

Back