Referring to the Menu Flow Chart as you proceed will help the setting procedure go smoothly.

(1) Select Manual Mode

Procedure

  1. Press several times to display the screen shown in the figure.



  2. Press several times to display the screen shown in the figure.

  3. Press .


  4. Press to select MANUAL.

  5. Press .

  6. Press twice.

(2) Enter the Distance between the Crop Marks

Enter the values that you made a note of in Step 1, No. 3.

Procedure

  1. Press to display the screen shown in the figure.

     

  2. Press to enter the horizontal distance (WIDTH) between the crop marks.


  3. Press to confirm.

  4. Press .

  5. Press to enter the vertical distance (LENGTH) between the crop marks.

  6. Press to confirm.

     

    (3) Enter the Offset Value

    Enter the values that you made a note of in Step 1, No. 4.

    If you want to further reduce the misalignment after seeing the result of printing and cutting, measure the amount of cutting line misalignment, and then add this measured value to or subtract this measured value from the offset values.
    Set the values as required.

    Procedure

  1. Press .

     

  2. Press to enter the amount of cutting line misalignment (in the width direction).

    In most cases enter 0 mm.

  3. Press to confirm.

  4. Press .

  5. Press to enter the amount of cutting line misalignment (in the length direction).

    In most cases enter 0 mm.


  6. Press to confirm.