Loadable Material Sizes

 

Width

Length

50 to 700mm (2 to 28 inches)

Flat Material: 100 mm (3-15/16 in.) or more

Roll Material: no restriction

CAUTION

Never load media that weighs over 5 kg (11 lb.).
The machine may fail to withstand the weight and tip over or cause the material
to fall.

(A) Cuttable material thickness

Material thickness of 0.1 mm or less*

(B) Maximum material thickness (including carrier paper)

0.3 mm or less (material of up to 1.0 mm thick can be loaded)*

*Conditions differ according to the type of blade. Refer to "General Guide Regarding Cutting Conditions."

Cuttable Area

 

Maximum cutting area

Width: 584 mm(22 in.)*

Length: 25000 mm (984-1/4in.)

*Maximum width can be extended up to 604 mm (23-3/4 in.) depending on settings. However, this may cause the pinch roller to leave marks on the deliverables. Exercise caution. For instructions on how to extend the cutting area, refer to "Extending the Cutting Area (EXTEND)."

Explanation of Cutting Area

The cutting area along the horizontal plane (the direction in which the cutting carriage moves) is determined by the position of the pinch rollers. The cutting area spans the length between the two rollers, minus approximately 1 mm on each side.

Type of specified material
Cutting area
ROLL or EDGE
<Width>: Distance between the two pinch rollers minus approximately 1 mm on each side
<Length>: Approx. 25000 mm
PIECE
<Width>: Distance between the two pinch rollers minus approximately 1 mm on each side
<Length>: Detected length (*1)

*1: If the detected length is 1600 mm or more, the machine determines the material to be ROLL, and the length of the cutting area is set to approximately 25000 mm.
However, the display does not show the length.