Extending the Cutting Area (EXTEND)

1. It is possible to extend the cutting area by up to 20 mm.

   Setting method: "Setting the Cutting Conditions"

   Depending on the design to be cut, the pinch rollers may pass over the top of the cutting line.

2. Example: Setting 0 mm → 10 mm

   

   

   When "EXTEND" was set after loading a material.

   The value of W displayed in the panel and acual cut width are different.When you set the upper example, the panel is displayed as shown in the figure below.

   

   *The panel indication is 210mm, but the actual cut width is 220mm

   

   When "EXTEND" was set before loading a material.

   The value of W displayed in the panel and acual cut width are same.When you set the upper example, the panel is displayed as shown in the below figure.

   

   

   (EXTEND)

   Stored in Memory: Yes

   Factory Default: 0.0 mm (OFF)

   Setting Range: 0.1 to 10.0 mm

Back Next