When using narrow material and when using material that is easily marked by the pinch rollers, use just the pinch rollers on the ends to feed the material. In this mode, the middle pinch rollers are not used (they are disabled).

Procedure

Make sure the material is loaded in the machine.
  1. Press [MENU] several times to display the screen shown in the figure.

     

  2. Press [Down] several times to display the screen shown in the figure.

  3. Press [Right].

  4. Press [Down] to display the screen shown in the figure.

  5. Press [Right].

  6. Press [Up ] or [Down] to display the screen shown in the figure.

    This setting will be enabled the next time the pinch rollers are lowered.

  7. Press [ENTER].

    Press [MENU] to return to the top screen.

Reducing the Force of the Middle Pinch Rollers


When using a wide sheet for which it is useful to use the middle pinch rollers in order to prevent the material from coming loose during cutting but is also easily marked by rollers, reduce the force with which the pinch rollers press down on the material.

Procedure

Make sure the material is loaded in the machine.
  1. Press [MENU] several times to display the screen shown in the figure.

     

  2. Press [Down] several times to display the screen shown in the figure.

  3. Press [Right].

  4. Press [Down] to display the screen shown in the figure.

  5. Press [Right].

  6. Press [Up ] or [Down] to set this to [SLIGHT].

    This setting will be enabled the next time the pinch rollers are lowered.

  7. Press [ENTER].

    Press [MENU] to return to the top screen.

Other Things That You Can Do