When to Use Tool Mode
■ When it is not possible to perform alignment in Sensor Mode
■ When printing and cutting without selecting the type of material
It is not possible to use Tool Mode when using only 3 crop marks.
Required Items
 |
 |
Alignment tool |
Material on which tool marks have been printed |
(1) Load the Material
Procedure
- Perform preparations for cutting.
Perform the procedure at the following link.
(2) Set Tool Mode
Procedure
- Press [MENU] several times to display the screen shown in the figure.
- Press [
] several times to display the screen shown in the figure.
- Press [
].
- Press [
] to select TOOL MODE.
- Press [ENTER].