Send Cutting Data and Perform Alignment

 

  1. Send the cutting data.

     

  2. The screen shown in the figure appears.

  3. Install the alignment tool.

    The installation method is the same as that of the cutting tool.

  4. When installation is complete, press [ENTER].

    The tool moves to a position near the lower-left crop mark and stops, and the screen shown in the figure appears.

  5. Use the [Up ], [Down ], [Right ], and [Left] buttons to align the tip of the alignment tool with tool mark 1.

    Hold down the alignment tool gently from above with your finger and check that the tip of the alignment tool overlaps the tool mark.

  6. Press [ENTER].

    The tool moves to a position near the lower-right crop mark, and the screen shown in the figure appears.

  7. Align the tip of the alignment tool with tool mark 2.

  8. Press [ENTER].

    The tool moves to a position near the upper-left crop mark, and the screen shown in the figure appears.

  9. Align the upper-left and upper-right tool marks in the same way.

  10. After aligning mark 4, press [ENTER].

    The screen shown in the figure appears.

  11. Remove the alignment tool and install the cutting tool.

  12. Press [ENTER].

     

  13. Press [ENTER].

    Cutting starts.

     

  14. To Redo Alignment

      You can press [MENU] during alignment to return to the previous screen and redo the alignment procedure.