Jump to main content
User's Manual
Basic Handling Methods
Cutting Output
Optimizing Quality and Efficiency
Maintenance
What to Do If
Appendix
INDEX
Search
Home
What to Do If
Output Quality Problems
Printing and Cutting Are Misaligned
Is a thick material being used?
Basic Handling Methods
Cutting Output
Optimizing Quality and Efficiency
Maintenance
What to Do If
Machine Problems
Cutting Output Problems
Output Quality Problems
Printing and Cutting Are Misaligned
Is a thick material being used?
Is the sensor reading inaccurate?
Was the machine set to feed forward some amount of material before cutting?
Uncut Areas Remain or Cut Edges Are Not Clean
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Misaligned Cutting Start and End Points
Messages on the Operation Panel
Appendix
Is a thick material being used?
Correct the cutting length according to the material actually used.
RELATED LINKS
Correcting Distance during Cutting Based on the Thickness of Material
Basic Handling Methods
Cutting Output
Optimizing Quality and Efficiency
Maintenance
What to Do If
Machine Problems
Cutting Output Problems
Output Quality Problems
Printing and Cutting Are Misaligned
Is a thick material being used?
Is the sensor reading inaccurate?
Was the machine set to feed forward some amount of material before cutting?
Uncut Areas Remain or Cut Edges Are Not Clean
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Misaligned Cutting Start and End Points
Messages on the Operation Panel
Appendix
Feedback
Was this information helpful?
1
2
3
4
5
NO
YES
Any additional feedback to help us improve.
Feedback
Thank you
