Measuring the Material Size

The size of the material loaded in the cutting machine can be measured and recorded in the machine. Raising the lever resets the memory of material size, and therefore the size of the material must be measured every time the lever is raised and lowered.
WARNING

Never touch the cutting carriage while measurement is in progress.

The cutting carriage moves at high speed. Coming into contact with the moving carriage may cause injury.

Procedure
  1. Turn on the power.
    Load the material in the machine, if it has not yet been loaded.
  2. When the following screen appears, press [▲], [▼], or [▶] to select a measurement mode.

    The cutting carriage moves at high speed to start measurement. When the measurement is finished, the cutting carriage stops and the measurements are displayed on the screen.


    MENU_On_SheetSize
    Display Settings Key Measurement mode Measurement location Notes
    Roll [▲] ROLL Width of material Max. 150 m (492.12 ft.)
    Edge [▼] Edge Front edge and width of material Max. 150 m (492.12 ft.)
    Single [▶] Single Front edge, width, and length of material Max. 10 m (32.80 ft.)*1
    *1 Do not select this mode for the measurement of roll materials or flat materials with a length of 1.6 m (63.00 in.) or more.
    MEMO Raise the lever to suspend measurement.