Jump to main content
User's Manual
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
What to Do If
Appendix
INDEX
INDEX
Search
Home
What to Do If
Output Quality Problems
Uncut Areas Remain or Cut Edges Are Not Clean
Is the tip of the blade broken?
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
What to Do If
Machine Problems
Cutting Output Problems
Output Quality Problems
Printing and Cutting Are Misaligned
Uncut Areas Remain or Cut Edges Are Not Clean
Are the blade and blade holder securely mounted?
Is the tip of the blade broken?
Is there any buildup of dust or material adhesive on the tip of the blade?
Is there any buildup of pieces of material or dust inside the blade holder?
Is a thick material being used?
Are the blade force and cutting speed appropriate for the material being cut?
Is the amount of blade offset correct?
Is the smoothing function set to Disabled?
Is the blade protector damaged or deformed?
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Misaligned Cutting Start and End Points
Messages on the Operation Panel
Appendix
Is the tip of the blade broken?
If it is, then replace the blade with a new one.
RELATED LINKS
Replacing the Blade
Basic Handling Methods
Output Method
Optimizing Quality and Efficiency
Maintenance
What to Do If
Machine Problems
Cutting Output Problems
Output Quality Problems
Printing and Cutting Are Misaligned
Uncut Areas Remain or Cut Edges Are Not Clean
Are the blade and blade holder securely mounted?
Is the tip of the blade broken?
Is there any buildup of dust or material adhesive on the tip of the blade?
Is there any buildup of pieces of material or dust inside the blade holder?
Is a thick material being used?
Are the blade force and cutting speed appropriate for the material being cut?
Is the amount of blade offset correct?
Is the smoothing function set to Disabled?
Is the blade protector damaged or deformed?
The Machine Cuts the Carrier Paper
The Machine Cuts the Same Area Twice
Misaligned Cutting Start and End Points
Messages on the Operation Panel
Appendix
Feedback
Was this information helpful?
1
2
3
4
5
NO
YES
Any additional feedback to help us improve.
Feedback
Thank you
