Setting Up Overlap Cutting with the Operation Panel

Using the operation panel, you can repetitively cut a preceding cutting job sent to the cutting machine.

MEMO To send jobs from the printer driver, open the Printing Preferences window, and then select the Back to Home check box.
Procedure
  1. Load the material and measure its size.
    Loading the Material
  2. Press [ON/OFF LINE] to switch to offline mode.
  3. Press [CUT TEST].
  4. Press [▶] several times to display the screen shown below.

    MENU_CUTTEST_Redo

  5. Press [ENTER].

    The current value is displayed on the screen.

    MENU_C-TEST_Redo_recut
  6. Press [▶] to select Recut.
  7. Press [▲] or [▼] to select the number of repetitions.
  8. Press [ENTER].

    Cutting starts. If you set the repetition count to 2 or higher, a confirmation message will appear at the end of the job, asking whether you want to execute the next job. Press [PAUSE/RESUME] to execute the next job.

  9. When the cutting is finished, press [ON/OFF LINE] to go back to the original screen.