Make sure that the material is loaded and set up correctly in the machine.
Place the pinch rollers with the necessary space at both edges of the material.
Be sure to place the pinch rollers on both edges of the material within the grit patterns that indicate the position of grit rollers. If the pinch rollers are not placed within the range of the grit patterns, the material cannot be fed properly.
If the material lifts up even when it is fixed by pinch rollers on both edges, or when loading large material, place pinch rollers in the middle of the material. When placing pinch rollers in the middle of the material, avoid placing them where there is cutting data as the pinch rollers may leave marks on the material.
Make sure that the material is loaded straight. If not, the material cannot be fed properly.
Follow the rules below to ensure correct crop mark reading when printing and cutting.
Avoid using any lighting that may shine horizontally onto the AAS sensor inside the cutting carriage.
