Correcting Distance during Cutting Based on the Thickness of Material

This correction should be performed when you want to accurately align the lengths of the cuts in the X and Y directions when cutting. This setting is applied to both cutting only and printing and cutting.

The movement distance of the material changes subtly depending on the material's thickness. This means that the length of a line when cut may differ from the length set in the cutting data.

MEMO It is possible to correct only the feed direction (X direction) or the width (Y direction).
Procedure
  1. Create cutting lines for a design whose feed direction (X direction) and width (Y direction) are set to the specified lengths.
    Create a simple design, such as a square.
    Creating and Outputting Cutting Data
    Feed-direction (X direction) length Width (Y direction) length
    250 to 2000 mm (9.85 to 78.74 in.) (Create this in units of 250 mm [9.84 in.].) 250 mm/500 mm (9.84 in./19.69 in.)
  2. Load the material in the machine.
    Loading the Material
  3. Perform cutting output.
    Cutting Method
  4. Measure the cut lengths (feed direction and width).
  5. Press [MISC].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  6. Correct the output length in the material feed direction.
    1. Press [▶] several times to display the screen shown below.

      MENU_MISC_ImageLengthai

    2. Press [ENTER].
    3. Press [◀] to select the number on the left and then press [▲] or [▼] to change the value to the feed-direction length created in step 1.
    4. Press [▶] to select the number on the right and then press [▲] or [▼] to change the value to the feed-direction length actually cut.
    5. Press [ENTER].
  7. Correct the output length for the width.
    1. Press [▶] to display the screen shown below.

      MENU_MISC_ImageWidth

    2. Press [ENTER].
    3. Press [◀] to select the number on the left and then press [▲] or [▼] to change the value to 250 mm (9.84 in.) or 500 mm (19.68 in.) (length of width created in step 1).
    4. Press [▶] to select the number on the right and then press [▲] or [▼] to change the value to the length of width actually cut.
    5. Press [ENTER].
  8. Press [ON/OFF LINE] to go back to the original screen.