Step 2: Performing Normal Cleaning (ER-641)

Procedure
  1. Press [▼] to display the following screen.


  2. Press [ENTER].
    The screen shown below appears, and then cleaning starts. The (approximate) remaining time for the procedure is displayed on the screen. (The display shown below is an example. "01:45" = "1 minute and 45 seconds")


    When finished, the screen shown below appears again.


  3. Press [▲].


  4. Press [ENTER].
    Perform a printing test again to check whether the dot drop-out and dot displacement have been corrected.
  5. Check to make sure the dot drop-out or dot displacement has been corrected.
    If the problem persists, try performing normal cleaning again. If the printer has been used for a long period, dot drop-outs may not be fixed even after performing normal cleaning two or three times. If this is the case, clean using a different method. For details on other cleaning methods, see the "User's Manual, Maintenance Edition."