Drying the Trailing Edge of the Printing Area on the Dryer

To dry the ink thoroughly, configure the settings so that the media is fed until the trailing edge of the printed area is put on the dryer after the printing is finished.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the following screen.


  3. Press [▶] twice to display the screen shown below.


  4. Press [▲] or [▼] to select "ENABLE" or "DISABLE".
    "ENABLE" Media feed is performed until the trailing edge of the printing area is positioned on the dryer. The margin between the print-end position and the next print-start position is set to a value of 130 mm (5.12 in.) when "OPTION DRYER" is set to "DISABLE" and 310 mm (12.2 in.) when it is set to "ENABLE".

    Using an Auxiliary Drying Unit (DU3)
    "DISABLE" Media feed stops when printing ends. This means that the trailing edge of the printing area is not fed to the dryer unless you continue with a subsequent printing operation.
  5. Press [ENTER] to confirm your entry.
  6. Press [MENU] to return to the original screen.
    MEMO

    Default setting: "DISABLE"