Disable skewing correction.

Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the following screen.


  3. Press [▶] or [▼] to display the following screen.

    MENU_SUBMENU_SKEWING_CORR
  4. Press [▶] to display the following screen.

    SKEWING_CORR_ENABLE_ENABLE
  5. Press [▲] or [▼] to select "DISABLE".
  6. Press [ENTER] to confirm your entry.
  7. Press [MENU] to return to the original screen.
    MEMO
    • Default setting: "ENABLE"
  8. Set up the media.
    For details on setting up the media, see the "User's Manual, Basic Edition."
    MEMO When "SKEWING CORR" is set to "DISABLE", the suction fan does not activate even when the leading edge of the media is passed between the pinch rollers and the grit rollers.

    After passing the leading edge of the media between the pinch rollers and the grit rollers, carry out the following procedure to temporarily secure the media, preventing it from falling off the machine.

    1. Lower the loading lever (rear).

      The media is held in place.

      At this time, the message "PRESS ENTER KEY TO SET UP" is displayed on the screen, but do not press [ENTER] yet, and proceed to the next step.


      Lower the loading lever (rear)

    2. (Move to the front of the printer.) Gently hold down the media and raise the loading lever (front).

      The media is released.


      Raise the loading lever (front side) while lightly pressing the media