Set the margins.

This sets the distance from the left or right media clamp to the corresponding left or right edge of the printing area.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the following screen.


  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [▶] to display the following screen.


  5. Press [▲] or [▼] to select the margin from those shown below.
    • "5 mm"
    • "10 mm"
    • "25 mm"
  6. Press [ENTER] to confirm your entry.

    • If the media has already been set up, the message "PRESS ENTER KEY TO SET UP" is displayed on the screen.

    • If the media has not yet been set up, press [MENU] to go back to the original screen.
    MEMO

    Default setting: "10 mm"