2. Clean the print heads.

Procedure
  1. Moisten a new cleaning stick with the cleaning liquid.
    IMPORTANT
    1. Be sure to use one of the included cleaning sticks.
    2. Do not use a previously used cleaning stick.
    3. Do not put a previously used cleaning stick into the cleaning liquid.


  2. Clean the locations shown in the following figure.
    Be especially careful to clean away any fibrous dust (lint).
    IMPORTANT Be careful not to wipe off the grooves on the head surface ().

    Cleaning the print head_groove

    1. Use the wide surface of the cleaning stick to wipe away any dirt from the edges and sides () of the head.
      Also wipe with the opposite, clean surface, ensuring that ink from the dirty surface does not adhere to the head.

      Head cleaning_ER-642_1

    2. Use the wide surface of the cleaning stick to wipe away any dirt from the area shown in the figure.
      If this area has any ink or cleaning liquid that appears likely to drip, use a dry cloth that is not fluffy to gently wipe away the ink or cleaning liquid.

      Head cleaning_ER-642_3

  3. Close the left cover.
  4. Check that the following screen is displayed, and then press [ENTER].


    The screen shown below appears, and then cleaning starts. The (approximate) remaining time for the procedure is displayed on the screen. (The display shown below is an example. [01:45] = "1 minute and 45 seconds")


    When cleaning finishes, the screen shown below appears again.