Separating the Media

After printing, use sheet cutting or perforated sheet cutting to separate the media.
Процедура
  1. Закройте переднюю крышку.
  2. Press [▲] or [▼] to set the media to the separation position.
    The media is separated at the position in the following figure. Use the media clamp holes as a guideline for this position.

    VG3_CutPos2

  3. Нажмите[FUNCTION].
  4. Press [▼] several times to select the sheet cutting method.
    "SHEET CUT" This separates the media.
    "PERFORATED CUT" The media is perforated without being separated.
  5. Нажмите[ENTER].
    Sheet cutting is executed.
    ПРИМЕЧАНИЕ
    • You can configure settings in the software RIP for automatic media separation after output has finished. For information on how to configure the settings, refer to the documentation for the software RIP you are using.
    • If the media is separated even when you select perforated sheet cutting, follow the procedure below to change to the setting that increases the uncut locations. If the media is heavy or has a large amount that is slack, it can be retained without being separated.
      1. Press [MENU].
      2. Press [▼] several times to display the following screen.

        MENU_SUBMENU

      3. Press [▶] once, and then press [▼] several times to display the screen shown below.

        MENU_SUBMENU_PERFORATEDCUT

      4. Press [▶], then [▼] to display the screen shown below.

        MENU_SUBMENU_PERFORATEDCUT_INCREASE UNCCUT_2

        ПРИМЕЧАНИЕ This is set to "STANDARD" by default.
      5. Press "ENTER" to confirm your entry.
    ВАЖНО!

    Separation Operations

    • When performing separation, do not use [▲] to pull the media back. If the distance from the end of the media to the separation location is short, separation may not be performed smoothly.
    Give Attention to the Media Composition
    • For some types of media, separation is not possible.
    • Some types of media may remain on the platen after separation. If the media remains on the platen, remove it by hand.