Using Sticky Media

This setting is used to peel off the media before starting printing when using media that sticks easily to the platen. This setting is effective to prevent media jams.

Note, however, that peeling off the media may cause unstable media feed. Leave this menu item set to "DISABLE" unless you specifically need to change it.

Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the following screen.


  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [▶] to display the following screen.


  5. Press [▲] or [▼] to select "ENABLE".
  6. Press [ENTER] to confirm your entry.
  7. Press [MENU] to go back to the original screen.
    MEMO

    Default setting: "DISABLE"