Important Notes on Handling and Use
This machine is a precision device. To ensure the full performance of this machine, be sure to observe the following important points. Failure to observe these points may not only result in loss of performance but may also cause malfunction or breakdown.
This machine is a precision device.
- Handle this machine carefully and never subject it to impacts or excessive force.
- Carefully clean away milling waste.
- Use this machine within the range of its specifications.
- Never attempt to move the spindle unit or rotary axis unit by hand with undue force.
- Never needlessly touch anywhere inside the machine except for locations specified in this manual.
Install this machine in a suitable location.
- Install this machine in a location that meets the specified conditions for temperature, humidity, and the like.
- Install this machine in a quiet, stable location offering good operating conditions.
- Never install this machine outside.
- Never install this machine in an environment where silicone substances (oil, grease, spray, etc.) are present. Doing so may cause poor switch contact or ionizer damage.
This machine becomes hot.
- Never cover the ventilation holes with cloth or anything else.
- Install this machine in a well-ventilated location.
About workpieces that can be milled with this machine
The following workpieces can be milled with this machine. Do not cut workpieces that are not listed below.
- Zirconia,
- PMMA, PEEK, composite resin,
- wax,
- dental non-cast cobalt-chromium alloy (unsintered)
About the milling bur
The tip of the milling bur is breakable. Handle the tool with care, being careful not to drop it.