Dust Collector

Because this machine cuts and mills material, milling waste is generated during milling.

Use a separately prepared dust collector by inserting the dust collection hose into the dust collection pipe of the machine.

IMPORTANT Milling cannot be performed without a dust collector.
WARNING

Be sure to turn on the dust collector.

Milling waste and workpieces are flammable and toxic.

WARNING

Never use a vacuum cleaner to clean up milling waste.

Picking up fine cuttings using an ordinary vacuum cleaner may result in fire or explosion.

The dust collector must meet the following conditions.

  • Static pressure: 26 kPa or more
  • 4 m³/min (141.26 ft.³/min) or more
  • Dust collection hose

    Either the dust collection hose included with the machine or a dust collection hose that meets the following specifications can be used.

    A

    • When covering the outer diameter of the dust collection pipe () with the dust collection hose ()
    • Dust collection hose inner diameter: 50.8 mm (2 in.)
    B
    • When inserting the dust collection hose () into the dust collection pipe ()
    • Dust collection hose outer diameter: 45.6 mm (1.8 in.)

    CleanerHose