Switching the Power On
Procedure
-
Attach the dust-proof cover to the milling area.
To prevent the work area from getting dirty from milling waste ejected from the milling area, attach the dust-proof cover before using this machine.
MEMO Attach the dust-proof cover so the handle is in the upper-right corner. Check that the magnets on the edge of the cover attach to the mounting frame. -
Close the following three covers.
- Milling area cover
- Adapter area cover
- Tool area cover
-
Switch on the machine's power switch.
The machine starts the initial operations. When the status light stops flashing and remains steadily lit, initialization is complete.IMPORTANT Do not open the covers during the initial operations.