Registering a Different Machine

Procedure
  1. Show VPanel.
    Displaying VPanel
  2. Turn off the power of the connected machine, and then disconnect the USB cable from the computer.
  3. Check that the icon under MACHINE STATUS is displayed in gray and that "OFFLINE" is displayed.
    offline
  4. Switch on the power of the machine to be newly connected, and then connect the USB cable to the computer.
    IMPORTANT
    • Configure the connection settings one machine at a time. Be sure to connect only the machine to be configured. Simultaneously connecting multiple machines with the same ID may lead to the computer shutting down or it being impossible to install the driver.
    • Use the included USB cable.
    • If you will connect a conversion cable, separately prepare a USB cable whose total length, including the length of the conversion cable, is 3 m (118.11 in.) or less. A longer total cable length may lead to malfunctions.
    • Do not use a USB hub. Connection may not be possible.
  5. Click Icon_VPanel_MachineSetting.
    SettingsTab

    The Machine settings - DWX-53DC window will appear.

  6. Click Set next to Machine ID setting on the General tab.
    ID_Setting

    TheSet ID - DWX-53DCscreen will appear.

  7. Select an unused ID, and then click OK.

    A is assigned as the ID of the machine by default. Since A is assigned to the first machine, be sure to select an ID from B to D for subsequent machines.

    IMPORTANT Do not set duplicate IDs. Simultaneously connecting multiple machines with the same ID may lead to the computer shutting down or it being impossible to install the driver.
    Select_ID2
  8. When the following window appears, click OK.

    The machine will restart, and then the driver for the machine with the new ID will be installed automatically.

    Select_ID3
  9. Restart VPanel.
    1. Exit VPanel.

      Right-click VPanel_TrayOnline in the task tray and click Exit.

      VPanel_for_DWX_TaskTray
    2. Start VPanel.
      Starting from the Windows Start Menu (or Start Screen)

      The selected ID is now enabled. Check that the machine has been added below MACHINE STATUS. Verify that the selected ID is displayed on the top window.

      Select_ID4
      IMPORTANT You can connect all the machines with configured settings to the computer using the USB cables. At this point, connecting more than one machine with the same ID at the same time may cause the computer to shut down.
  10. To connect a third or fourth machine, repeat steps 2 to 9.