Switching the Power On

Procedure
  1. Close the front cover if it is open.

    Hold the parts shown in the figure with both hands and close the cover.

    DWX-43W_main_09
  2. Switch on the machine's power switch.
    The machine starts the initial operations. When the status light stops flashing and remains steadily lit, the initial operations are complete.
    DWX-43W_power_01
    IMPORTANT Do not open the front cover during the initial operations.
    MEMO

    To prevent milling waste from adhering to the inside of the machine, it performs a regular flushing operation, which automatically cleans the inside of the machine once every 12 hours from the point the machine is turned on.

    Even when the machine is not in use, it regularly sprays coolant onto the inside of the front cover to wash off milling waste. Pay attention to the following points.

    • Leave the machine turned on at all times.
    • Supply compressed air from the compressor at all times.
    • Close the front cover.
    • Attach the coolant tank containing coolant.
    • Do not set other parts or materials in the stocker for the dummy pin unless instructed to do so. Doing so may cause impact during operation and damage the machine.
    • Do not leave a tool, correction jig, or other unnecessary item inside the front cover. These items may cause impact or become caught during operation and damage the machine.