Step 1: Removing the Retainers

Two retainers are attached to this machine to protect it from vibration during shipment. After installing this machine, remove all the retainers.

  • Be sure to remove the retainer. Switching the power on with retainers attached to this machine may cause faulty operation or a breakdown.
  • The retainers will be required when moving the machine to a different location. Store them carefully so that they do not get misplaced.
IMPORTANT Before removing the retainers, be sure to check that the power cord is not connected.
Procedure
  1. Open the front cover.

    Hold the parts shown in the figure below with both hands and open the cover.

    DWX-43W_main_10
  2. Remove the retainer.
    1. Pull the bottom of the retainer (large) toward you, and slide the retainer with it facing up to remove it.
      DWX-43W_retainer_02
    2. Remove the retainer (small).
      DWX-43W_retainer_01
  3. Close the front cover.