Load the media in the take-up unit.
Procedure
- Follow the procedure below to load a paper tube on the media holders of the take-up unit.Prepare a paper tube wider than the media that has been set up.IMPORTANT Paper tubes are consumable items.
Watch the condition of the paper tube and replace at an appropriate time so that the media can be taken up in good working order.
-
Hold down
on the operation panel to feed out the media until the tip of the media reaches the paper tube.
Media is fed out 30 mm (1.18 in.) each time you press this button. Holding down the button lets you feed out paper continuously.
MEMO Feed out the media until it can wrap around at least 1/4 of the paper tube.
- Follow the procedure below to adjust the positions of the media holders.
- Follow the procedure below to secure the media on the paper tube.
Secure the media in place so it is fed forward.
- Tap OK.
-
Attach the media guide near the right end of the media.
-
In the same manner, attach the media guide near the left end of the media.