Performing Normal Cleaning

MEMO
  • Printing tests after cleaning

    If the media has already been set up, the After cleaning, perform a printing test. menu appears on the Normal Cleaning screen. When this setting is turned on, a printing test is performed after cleaning.

  • Aborting cleaning

    To abort cleaning or the printing test after cleaning, tap Panel_Icon_Home to return to the home screen, and then cancel the cleaning or the printing test.

Procedure
  1. If media has not been loaded, set it up.
  2. If a printing test has not been performed, perform one.
  3. Check for the group with dot drop-out or dot displacement by viewing the results of the printing test.
    The space from "A" to "B" is group A. The space from "B" to the right side is group B.


    MEMO

    If the printing-test results are difficult to interpret

    • Check the results in a bright location, changing your line of vision. They are visible using the reflection of the light.

    • Shine a black light on the printed media to check for the locations on which structural ink was printed. Depending on the media, these locations may be difficult to check. If it is difficult to see this ink, switch to a different media and perform the printing test again.
  4. Tap Panel_Icon_Menu.
  5. Tap Cleaning - Normal Cleaning.
  6. Select the group of print heads to clean.

    Panel_select-head-group
  7. Tap Execute.
    Cleaning will start. The status is displayed as Normal cleaning in progress. at the top of the operation panel.

    On completion, you will return to the original screen.

  8. Tap Panel_Icon_Back.
  9. Perform a printing test again.
  10. Check to make sure the dot drop-out or dot displacement has been corrected.
    If the problem persists, try performing normal cleaning again. If the printer has been used for a long period, dot drop-outs may not be fixed even after performing normal cleaning two or three times. If this is the case, clean using a different method.