Turning the Power Off

WARNING

Remove any loaded media or switch off the sub power when printing is not being performed.

The continued application of heat at a single location may cause the release of toxic gases from the media or pose a fire hazard.

Procedure
  1. Tap Panel_Icon_SheetCut Sheet Cutting.
  2. Tap Execute on the Sheet Cutting screen.

    The media is separated from the roll.

    WARNING

    High Temperature

    Immediately after coming out of the oven, the separated media is very hot. Leave the media alone for at least 10 seconds, only touching it after it cools down.

  3. Raise the loading lever and remove the media.
    1. Raise the loading lever.

      DA-640_lever-up

    2. Press the manual switch on the take-up unit to take up all the excess media.

      TU_rolled-up

    3. Hold the media holder flange on the back of the printer, turning this flange in the take-up direction to take up all the media fed out from the roll.

      VG3_FrangePos

    4. Remove the media from the media holder and store the media.
      Store the media in a location with low humidity. You are recommended to implement countermeasures against moisture such as by covering the media with a vinyl sheet containing desiccant.
  4. Tap Panel_Icon_ONOFF on the operation panel.

    The confirmation window appears.

  5. Tap Yes.

    Cool the oven. The sub power switches off after the oven cools to the prescribed temperature.

    Depending on the temperature of the oven, this cooling may take 10 minutes or more.