Performing Printing

This section introduces how to print the design file on a specific printer.

You can use a computer on which Roland DG Connect Hub and VersaWorks are running to specify a printer registered in VersaWorks as the output destination.

Procedure
  1. If Roland DG Connect Hub and VersaWorks are not running, start them.
  2. Click Print in the upper-right corner of the window.

    The Print Quality window appears.

    If editing of the design is in progress, perform the operation after saving the design file.

  3. Select the printer and printing settings.
    MEMO The printing settings selected in this step are given higher priority than the queue A printing settings of the specified printer registered in VersaWorks.
    MEMO Depending on the status of the connection with VersaWorks, the Warning window may appear.

    Check that Roland DG Connect Hub and VersaWorks are running, and then click Refresh or log out from and back in to this software.

  4. Click Send to VersaWorks.

    The print job is sent to VersaWorks and output to the printer according to the specified printing settings.