Setting the Base Point

Set the base point to determine the printing position on the loaded object to be printed on.

The base point () indicates the lower-right corner of the printing area () (: feed direction, : scan direction).

The base point will be cleared after printing.



MEMO

  • Note that the left and right positions are not restored to their defaults for test patterns.

Procedure
  1. Press [◀] while the following screen is displayed.
    The cutting carriage moves to within the printing area.

    MENU_WIDTH

  2. Press [◀], [▶], [▲] or [▼] to move the center of the cylinder in the figure to the position that you want to set as the base point.
    Only the cutting carriage moves.
    CO-640_cutting-carriage
    • : Base point (right edge of the output area)
  3. Once the position has been decided, press [FUNCTION] to display the screen shown below.


  4. Press ENTER to confirm your entry.
    When the screen displays the character B together with the printable width at the location (as shown in the following figure), setting is completed.
    MENU_TOP_SCREEN_BASE
    MEMO After the location of the base point has been set, do not change this location in the feed direction. Printing will be performed from the changed location.