Speeding Up Output for Deep Objects

You can reduce the output time by shortening the illumination distance of the UV-LED lamp after printing.

IMPORTANT If this distance is too short, the UV-LED lamp's illumination time will also be too short, possibly preventing the ink from being cured. Be sure to try printing and check that the ink is cured.
MEMO
  • This setting is effective for objects that have high ink adhesion. Check the material of the object before printing.
  • Using primer and degreasing the object with anhydrous ethanol or isopropyl alcohol are also effective methods for increasing the adhesion of the ink.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the following screen.


  3. Press [▶] once, and then press [▼] several times to display the screen shown below.
    MENU_SUBMENU_AFTERCURE_LEN_01
  4. Press [▶] to display the following screen.
    MENU_SUBMENU_AFTERCURE_LEN_02
  5. Press [▲] or [▼] to set the illumination distance of the UV-LED lamp.
    The smaller the number, the shorter the illumination distance of the UV-LED lamp after printing.
    MEMO
    • You can change the illumination distance of the UV-LED lamp in increments of 5%.
    • Default setting: 100%
  6. Press [ENTER] to confirm your entry.
  7. Press [MENU] to return to the original screen.